71' Cuda Grille: Broken Piece to Repo

Posted By: Topcat

71' Cuda Grille: Broken Piece to Repo - 12/30/11 06:07 AM

My 71' Cuda grille:

Needs a piece put back on.
Fabricate a piece? Get lucky finding one?

Suggestions please on how to re-do.
Can a specialty plastic shop fab a piece?

Would prefer ideas on DIY vs. send out.

Posted By: MLR426

Re: 71' Cuda Grille: Broken Piece to Repo - 12/30/11 03:41 PM

It's junk wrap it up I'll take it LOL. That is a common and easy repair. Find the piece and have it repaired.

logan426

Posted By: Tommy The Chryco

Re: 71' Cuda Grille: Broken Piece to Repo - 12/30/11 06:01 PM

easy fix!

www.tommythechryco.ca

Posted By: PaddleOn

Re: 71' Cuda Grille: Broken Piece to Repo - 12/31/11 12:29 AM

you can get some flat abs sheet, then make patterns, heat, cut, bend, shape, weld. that was the first generation method of repair when i was doing them commercaally if/when i could not find good used ones...

Then, I went to a 3d scanned cad file and had them 3d printed, not cheap, but saved time... so at shop rate it was about a wash, but made a lot better repair.