fender fasteners..who knows the right size..??

There are two threaded studs that fasten the fenders to the rocker area on many mopars..These rust and break most of the time..I found a companythat has replacements..Does anyone know the exact size these studs are supposed to be..two per side right behind the front tire..They look like the studs on the left side of this photo..I need the proper sizes for my Mopar.

Just measured the ones from the 71 Charger I have apart. Its 1.75" long. The nut is 1/2" size wrench. Threads look like standard fender bolt pattern.
Hope that helps.

Go to http://www.amkproducts.com/Catalog_PDF.htm

For double ended studs, click on catalog page 129 and see part B-11007.

For Keps nuts, page 53, part B-13242.

These connections have thick and thin galvanized washers used as shims to move the fenders in/out. See page 181, parts B-13014 and B-13740.

The stud and nut are exact Chrysler reproductions. The washers are similar - not the same O.D., but they are hidden.

FWIW, most vendors who sell reproduction Chrysler fasteners are just re-selling AMK stuff.

Quote:

---

Go to http://www.amkproducts.com/Catalog_PDF.htm

For double ended studs, click on catalog page 129 and see part B-11007.

For Keps nuts, page 53, part B-13242.

These connections have thick and thin galvanized washers used as shims to move the fenders in/out. See page 181, parts B-13014 and B-13740.

The stud and nut are exact Chrysler reproductions. The washers are similar - not the same O.D., but they are hidden.

FWIW, most vendors who sell reproduction Chrysler fasteners are just re-selling AMK stuff.

---

Terriffic info..