Master cylinder Mods

Posted By: Publicbottle

Master cylinder Mods - 05/19/08 10:56 PM

So, I thought there was a residual pressure valve in the Master cylinder (rear resevoir) that needed to be removed to run rear disc brakes.....i took my new one from NAPA apart as well as my old original from my 69 dart and found nothing in either of them...
So my question is....what do i need to do to my master cylinder to run 4 wheel disc brakes??

Posted By: Lefty

Re: Master cylinder Mods - 05/20/08 03:07 AM

Quote:

what do i need to do to my master cylinder to run 4 wheel disc brakes??

Nothing unless the brake balance is biased too much to the rear. 4 wheel disc setups don't need a hold off valve, proportioning valve, combination valve, etc... I doubt you will have any problem with the MC you're using.