Stock Edelbrock Valve Springs and MP 528 Cam

Stock Edelbrock Valve Springs and MP 528 Cam - 05/24/11 03:10 PM

I have a 440 that the build is 5 years old, with stock ootb Eddy valve springs.

I have on the shelf a MP 528 that is finally going into the motor.

Will the eddy vs be alright for this cam?

Bryan

Posted By: superwrench

Re: Stock Edelbrock Valve Springs and MP 528 Cam - 05/24/11 03:26 PM

No problem. You can use the stock Eddy springs with just about anything except roller up to around .570" or so. Then go up to a Comp 928 or equivilent.

Posted By: NewMemberAgain

Re: Stock Edelbrock Valve Springs and MP 528 Cam - 05/24/11 04:08 PM

Thank you for that.

Bryan

Posted By: 69L78Nova

Re: Stock Edelbrock Valve Springs and MP 528 Cam - 05/24/11 04:14 PM

If you figure in the valve lash for that cam, you're back down to around .500" or so anyway. I have used an MP 292/509 with Edelbrock heads and their stock springs with no problems whatsoever.

Posted By: Von

Re: Stock Edelbrock Valve Springs and MP 528 Cam - 05/24/11 04:22 PM

What is the open PSI on the eddy springs?

Posted By: pro6pakRR

Re: Stock Edelbrock Valve Springs and MP 528 Cam - 05/25/11 05:21 AM

Quote:

I have a 440 that the build is 5 years old, with stock ootb Eddy valve springs.

I have on the shelf a MP 528 that is finally going into the motor.

Will the eddy vs be alright for this cam?

Bryan

I've run a mopar 590 cam with 1.6 rockers on my ootb eddy's