Posted By: boomerodell
ebody clutch pedal questions - 09/16/08 12:45 AM
What side of the clutch pedal should the pin for the rod be? on the brake side or out side?
Posted By: RTDaddy
Re: ebody clutch pedal questions - 09/16/08 12:53 AM
Pin for the rod is on the brake side. The pin on the outside is for the neutral safety switch. Hope this helps.
"IF YOU'RE UNDER CONTROL, YOU AIN'T GOING FAST ENOUGH."
Posted By: boomerodell
Re: ebody clutch pedal questions - 09/16/08 12:59 AM
Thanks, it does. Doing an auto to manual conversion and trying to figure this stuff out. However the pedals that I have do not have a stud on the brake side, just the outside towards the top. There is a hole lower on the pedal, is this where the stud should be?
Posted By: tecmopar
Re: ebody clutch pedal questions - 09/16/08 07:30 AM
The rod goes on the pin facing the brake pedal the other higher pin is for the overcenter spring and the hole in the pedal arm itself, about 1/4", is for the plastic button for the clutch switch. If you can, post a pic of the pedals because in some ways it sounds like you have a set of A-body pedals.