Posted By: Von
BB run in stand measurements - 04/04/11 08:31 PM
Ive run across a run in stand. The stand has only had sb mopars on it, and Im needing one for BBs. Im needing some measurements to see if the stand will work with a BB, most notably oil pan clearance.
I also need the measurment from center of motor mount to center of motor mount, more or less.
Im looking for the measurement from the lower rear bellhousing bolts (trans side) to the pan rail on a BB.
This stand has very little room between the lower bellhousing hole and a support that would be below the pan. It doesnt look like enough room for a deep sump pan to fit. I can always move the rear holes up....I think.
Any help greatly appreciated.
Thanks
I also need the measurment from center of motor mount to center of motor mount, more or less.
Im looking for the measurement from the lower rear bellhousing bolts (trans side) to the pan rail on a BB.
This stand has very little room between the lower bellhousing hole and a support that would be below the pan. It doesnt look like enough room for a deep sump pan to fit. I can always move the rear holes up....I think.
Any help greatly appreciated.
Thanks