MOOG upper control arm bushings

Anyone here use the moog offset upper control arm bushings. What would keep them from rotating after installation and making the problem worse?

They are pressed in like the originals.The hole is offset in the rubber.They also dont get installed like the instructions say.they go in opposite.Rocky

Would they have to be tack welded in the desired position so that they will not move or will they not rotate any once installed? I need to get about 2 more degrees according to the guy who did my alignment.

If they press in real tight & most do they will not move. & remind your alignment guy to tighten the UCA cam bolt nuts TIGHT when he's done

Thanks guys. summit them for under 50.00 for both sets.

These were in my car for 17 years 1994-2010 and about 80K miles. Still look fine.



Use these instructions...