Posted By: finadk
New Pistons Valve relief machined to edge is this OK? - 02/05/11 11:17 PM
I am assembling my 408 Stroker. These are custom made Ross Pistons and the valve relief's on all 8 are machined right to the edge of the piston. On three of them it is so close that it is below the top of the piston. Is this ok?
I will call Ross on Monday but figured i would get a response here pretty quick.
URL=http://rides.webshots.com/photo/2781308980028738248kQYVTF][/URL]
URL=http://rides.webshots.com/photo/2631684570028738248IHvAMP][/URL]
I will call Ross on Monday but figured i would get a response here pretty quick.
URL=http://rides.webshots.com/photo/2781308980028738248kQYVTF][/URL]
URL=http://rides.webshots.com/photo/2631684570028738248IHvAMP][/URL]