Moparts

Help with Dana 60, 1350 yoke swap problems???

Posted By: jbc426

Help with Dana 60, 1350 yoke swap problems??? - 02/05/11 02:57 PM

I have a late '60's Dana 60. I switched over to a 1350 yoke, tightend up the pinion nut to about 250 ftlbs and it locked up the rearend. I loosened it back up, and it spins fine. I tightened the nut back up until there was some drag on it when it turned and put the car back together. I think the nut backed off a bit as I'm getting a vibration on the freeway that seems to be getting stronger. I'm pulling it apart this morning to verify that the nut has loosened up. The yoke & new nut was the only thing I changed.

Attached picture 6458205-Christmas08002(Large).jpg
Posted By: jbc426

Re: Help with Dana 60, 1350 yoke swap problems??? - 02/05/11 05:47 PM

OK, so I take the thing back off, put it back on....same thing. Take it off again, clean the oil off the threads with carb cleaner, loctite red it, start torqueing it down; and am able to put 250 ft lbs on it and now it spins freely albiet with a slight drag just like it is supposed to. Go figure.
Posted By: bomber1965

Re: Help with Dana 60, 1350 yoke swap problems??? - 02/06/11 01:42 AM

Archives


Posted By: jbc426

Re: Help with Dana 60, 1350 yoke swap problems??? - 02/06/11 04:59 AM

I saw that, but mine would not turn after I tried it the first few times. Then it worked like the thread says on the third try? Must have been a charm.
© 2024 Moparts Forums