FAST #170402 Module Question

I am wondering if the FAST #170402 module is small enough to hide inside of the center console of a 70 Challenger when not in use.
I am trying to decide on either buying two of the #170634 analog gages or go with one of the #170402 with dual sensors. My main concern is where to mount the twin gage bracket for the two 634's or where to hide the #402 module when not in use.

Thanks

Since the first question did not go so well, ( ), how about this one.

Where do you store the #170402 module in your street car while it is hooked up? Do you mount them or do you keep them in your lap while you drive, or do you keep them under your seat or do you disconnect them and only use them for tuning?

Can someone give me some general dimensions of the unit to give me some idea how big it is? I would like to see some pictures of where you store or mount the #170402 or the 170634 analog gages too.

Thanks

they sell a suction cup with an arm that I mounted under my dash, I put it on the windshield while mine was on the dyno.


part number : 170493

DVJ,
That is a cool bracket and I have not seen it before. Thank you for posting the picture.

Can anyone post other mounting brackets/locations for the #170402 or for the #170634 unit (shown below)?

Thanks

DJV,
Do you keep the unit plugged in all of the time?

Thanks

Yes, but mine is the controller for the FAST EZ efi setup -

Thanks DJV.

Where are all of the members running these two units? I figured that I would have several replies showing where everyone is mounting them.

I am assuming that not allot are using the #170634 (anolog, see below) yet, is this true? If so, why not?

Thanks