Posted By: Zapp
70 Challenger drive shaft length - 11/09/10 02:51 PM
Sorry if this is covered somewhere I couldnt find it.
I need all lengths necessary to order a driveshaft for my Challenger.
I have Hemi, 727 and Strange Dana that Im having Cass build soon.
Thanks for any help even if its to say look here idiot..............and a link
Posted By: Boosted
Re: 70 Challenger drive shat length - 11/09/10 03:06 PM
I asked this same question and the result was that I need to buy a yoke.. slip it in the trans to where there is about 3/4 to 1" out and measure center of joint to the center of the joint on the rear-end to get a true shaft..
Posted By: Zapp
Re: 70 Challenger drive shat length - 11/09/10 04:06 PM
Thats exactly what Id do except the car is still on Rotisserie and I dont have the diff yet. I just want to make the most of our strong Aussie Dollar and buy some bits now to save some bucks
Posted By: stumpy
Re: 70 Challenger drive shat length - 11/09/10 04:33 PM
Save your time and money by waiting until you can get a real measurement. A 1/2" off either way and you will be redoing the shaft.
Posted By: BDW
Re: 70 Challenger drive shat length - 11/09/10 11:33 PM
If your motor is located in the stock position, the stock length driveshaft will work.
They didn't custom build each part.
Posted By: MLR426
Re: 70 Challenger drive shat length - 11/10/10 02:00 PM
The rear axle should be on jack stands so the suspension is loaded with the cars weight for a good measurement.
Logan426
Posted By: Rick_Ehrenberg
Re: 70 Challenger drive shaft length - 11/10/10 04:28 PM
One inch would work with the OEM "long" slip yoke, although every stocker I've ever seen has been more like 1/4" to the back of the seal's boot. If using an aftermarket short yoke, be very careful, 1" would be too much for sure.
Rick
Posted By: TheOtherDodge
Re: 70 Challenger drive shaft length - 11/10/10 08:38 PM
I have one that I ran in my Challenger with a 727 and Dana. Car went 9.3's at 3500 lbs. Let me know.
James
Posted By: Zapp
Re: 70 Challenger drive shaft length - 11/11/10 09:27 AM
Thanks but that Chart doent cover Hemi 727 lengths which is what I need. Shouldn't matter but I am leaning toward Carbon Fibre.
Posted By: BDW
Re: 70 Challenger drive shaft length - 11/11/10 12:45 PM
Posted By: Snoopy
Re: 70 Challenger drive shaft length - 11/16/10 03:31 AM
From the factory 70-71 parts book.
Challenger - 44.60" ctr-ctr 3 1/4" Dia.