360 Magnum bore size.

I am looking at getting a 360 Magnum stroker engine that is bored at 4.04. Is this considered to be a lot, or is this bore size ok for a 410 ci street engine? Also, what is a good temperature to run?

Stock bore size is 4.000 So, it is a kit with .040 over bore. It is a lot to go, you need to check the condition/size of the bore in the block you are using before ordering the pistons.

The magnum's tend to not like a bore that is to big over .030, I would get it sonic checked first. Just the consensus in the Magnum motor users.