Posted By: welderboy
Trans help needed! - 08/21/08 04:16 PM
Have an early 904 trans going to a '72 /6 - problem is new converter hub measures about 1.55" and crank end is 1.81". Can't use a later converter because spline count is different. Any thoughts? Thanks!
Posted By: John_Kunkel
Re: Trans help needed! - 08/21/08 11:31 PM
There are reducer rings available, can't remember who offers them; or have one made locally.
Posted By: RapidRobert
Re: Trans help needed! - 08/22/08 12:07 AM
www.wildcatauto.com the last one I purchased from them was $20 to my door.
Posted By: welderboy
Re: Trans help needed! - 08/22/08 11:57 AM
Thanks John and Robert - made a midnite run to the shop where I used to work and made a spacer from a 3000 psi socket weld fitting.