Posted By: Gramps06
Carter fuel pump rebuild - 08/02/10 05:34 PM
New to this site, so please forgive my ignorance if any...
When rebuilding a Carter mechanical fuel pump (M6902/M6903), is there a special tool required to remove/install the check valves? Or does one simply use needle nose pliers/vise-grips? Special end spanner wrench? Also, when installing the new diapgragm (assembly), how are the shaft end caps (rivets?) installed and/or crimped?
When rebuilding a Carter mechanical fuel pump (M6902/M6903), is there a special tool required to remove/install the check valves? Or does one simply use needle nose pliers/vise-grips? Special end spanner wrench? Also, when installing the new diapgragm (assembly), how are the shaft end caps (rivets?) installed and/or crimped?