What do I need to pull a coulpe of LCA's

I have a chance to get a pair of LCA's off a 75 A-body. What tools will I need to pull them? How hard are they to remove?
Thanks!!!!

socket/wrench to bust the nut off the lower BJ

BFH/pickle fork/ball joint seperater tool

socket for pivot pin nut

pliers for the t-bar clip

socket to run the t-bar adjuster down off the t-bar

prybar/BFH/vise grip to grab t-bar to hammer it back..maybe..depends if its stuck or the t-bar clamp tool

nut to remove strut rod nut..I pull the strut with the LCA myself..but either end..diff size so bring both size

some thing to remove the pin in the end of the strut rod if its there

maybe a jack if its not up

small tools for shock and misc stuff...wheel bearing/calaper/brake pads/lug wrench

some one to help you carry tools/parts is allways nice

not to hard to do..just depends on the car and where its at and maybe the condition of stuff

good luck

Mike !! You forgot a set of your special jackstands and a six-pack.

oh yea square jack stands and a couple cold ones before/during/after

Thanks!!!