Oil drain plug leaking. Any suggestions?

I have a deep Milodon oil pan on the 340 in the 72 Cuda, so deep and to low.. I had a low speed scrape the other night and now I have a drip. Anybody have a suggestion after I remove the oil plug? I think maybe in the future I will replace pan with a pan thats not as dangerous. Plug was a little loose after hit,but still leaking after I tightened. Thanks guys.. Wish I was in Carlisle

Aren't the bolts on those on the backside instead of the bottom?

Anyways, wrap the threads of the bolt with a little teflon tape and then thread it into the hole. This should seal the leak + keep the bolt snug. Pay attention to which way the tape is wrapped since if you do it backwards the tape will want to bunch up going in.

Yes the bolt is on the backside. Thanks

You may have cracked the pan, I did that once doing a jump. Right where the drain plug is.

If there's a gasket on the bolt like normal and it's not damaged it doesn't matter if the threads are sealed or not.

Skit plate time.

https://board.moparts.org/ubbthreads/show...rue#Post5808599