Posted By: 1E2C
Division bar seals??? - 05/24/10 01:39 AM
Well, I've tried several routes so far and not found the correct seals for the division bar. Has anyone seen a similar setup to what's in the picture on any other cars and/or know where I can get the right stuff? The car in question is a 65 Polara 500. It's a two piece setup, separate seals on the inside and outside of the glass frame and it slides into a channel that's about 3/16" wide and the upper lips are ~ 1/16" from the backside.
Thanks for any help,
Mike
Thanks for any help,
Mike