5.7 hemi, what size flywheel bolts?

i have a 2003 5.7 hemi that i am putting a T56 6 speed behind. i have a 130 tooth flywheel and need the bolts. i cant find anywhere that sells them for a hemi or any place that says what size they are. i believe they are metric.
also i need a pilot bushing to fit the hemi and the T56. the hole in the hemi crank is 1" and the shaft on the T56 is small , like .600 i believe. i was thinking of having a machine shop make one if i cant find one to work.

thanks!

I used:

06504398, M10x1.0x26.0 Bolt

get them from the dealer

Actually it's 6504398 (drop the 0) they run about $1.75 ea.

Also the pilot bearing mounts to the crank register like the 5.2/5.9 magnums (it's the same part) if that helps you find a bearing. I'm using a 833OD with my 04 5.7 hemi.

same pilot bearing is awsome. i all ready have one that should work then.
is the dealer the only place to get the flywheel bolts? or just the best

How does the hole in your floor look after the cuts? How did you reinforce the torsion bar cross member?

Sounds like a nice setup.
thanks
Darren

Quote:

---

i have a 2003 5.7 hemi that i am putting a T56 6 speed behind. i have a 130 tooth flywheel and need the bolts. i cant find anywhere that sells them for a hemi or any place that says what size they are. i believe they are metric.
also i need a pilot bushing to fit the hemi and the T56. the hole in the hemi crank is 1" and the shaft on the T56 is small , like .600 i believe. i was thinking of having a machine shop make one if i cant find one to work.

thanks!

---