Where did you mount your ignition box?

Is this the box your looking for? It is in an A-Body, I have never had a problem.

On my dart, I put the digital 6 box on the fenderwell for easy access to the pots (facing back towards firewall)

On my satellite I got a little creative and located the msd6a on the underside of the battery tray. Just barely fits between fenderwell and the brackets but it's nice having it tucked outta the way.

I seen one of the members here out it under the battery tray. Cleans up the engine compartment a little.

For some reason some of the MSD units make a lot of noise, so mounting it into the interior is not a choice.

I have hid them on the radiator support next to the headlights, and under the dash.

Fire wall

Under the battery tray on my '63 Dodge

On the right inner fender like SeventyGTX on my '71 'Cuda.

Mount my in between the two front seats (MSD-6)on little rubber mounts pretty easy to access the 2-step.

68 GTX Mopar chrome box mounted to bracket on back of intake. Bracket bolts to the rear valley pan bar. Bracket has slots cut into it for heat. Hides it nicely when hood is open.

mines on the inner fender behind battery

This is the bracket i used. It's for Mopar boxes. Mounts on back of intake. Got it on ebay. Seller is Rocketresto

Under my horn on the radiator support. It's been flawless since 2000........

Good luck

mounted mine under left front fender.
remember,heat is what kills them.

they like that air on the backside of them, best to put it a cool area in the engine bay.

I put an MSD6 box in the cab of my truck. With a 440, long tube headers, and almost no muffler I can still hear that stupid thing squealing away. I'll never put another in the cab.

On my battery tray with the battery in the trunk. I fabricated a bracket that mounts the MSD and injection control computer on a repop tray. There is a cooling opening for the battery that helps keep it all cool when rolling.

I always use MSD 6al's so I have a rev limiter and I always mount them on the underside of the battery tray!

I was thinking about putting a MSD 6AL in the trunk behind the spare. Maybe make up a separate harness for the MSD, fuel pump, and speakers and run it down the rh side of the car?

Well I mounted it. I HATE messy, hacked, criss crossed wiring everywhere so I try to keep everything as neat as possible.

I mounted it on the firewall right under the voltage regulator so that its kind of hidden by the air cleaner and blends in with the other wiring stuff, and a GTX air cleaner would hide it even better. Most importantly I only need 6 inches of wire to tie it into the ballast resistor and I can run it with the rest of the wiring harness to the distributor and coil.


Thanks for the input guys.