Posted By: Dart6pak
Can you swap PP833 overdrive into a standard case - 04/27/10 03:03 AM
I have an aluminum case overdrive transmission that I would like to convert into a cast standard case.
Can this be done?
Will cluster shaft fit
Can the 308 input bearing be changed to a 307?
Any input would be greatly appreciated
Posted By: Jim_Lusk
Re: Can you swap PP833 overdrive into a standard case - 04/27/10 03:51 AM
Yes. All gears and mainshaft MUST be swapped together. Use the cluster pin from the cast iron case. Also use the 307 bearing and corresponding front bearing retainer. Some tailhousings used a different bearing. If this is the case, use the bearing from the iron tailhousing.
The only caveat here is that you can't swap a long tail OD mainshaft into a short tailhousing A/F body
Posted By: imfixinmopars426
Re: Can you swap PP833 overdrive into a standard case - 04/27/10 02:09 PM
od truck is same as a b/e length
Posted By: JohnRR
Re: Can you swap PP833 overdrive into a standard case - 04/27/10 02:37 PM
The cluster shaft will work but it's a little short and you'll want to seal it somehow or it will leak ... been there got the spot on the floor to show for it .