Posted By: crowbait
holley carb question - 04/05/10 10:45 PM
How do you remove the venturis from the main body?
holley carb question
Posted By: Alikazam
Re: holley carb question - 04/06/10 04:47 AM
I believe they are pressed in, but I'm not 100% sure of that. Unless you have a race carb I don't think removal is common practice. I take it you mean the boosters (the bronze parts in the middle of each venturi), correct?
Posted By: goldmember
Re: holley carb question - 04/06/10 04:54 AM
This is one of those,if you have to ask maybe you should not be messing with it. Unless your making a throttle body?
Posted By: crowbait
Re: holley carb question - 04/07/10 12:45 AM
It appears to be pressed in towards the metering plate.I was wondering if anyone has sucessfully replaced one and had an operable carb when they were done. Its a holley six pack center carb,if it matters.
thanks
guys
thanks
guys
Posted By: Locomotion
Re: holley carb question - 04/07/10 03:37 PM
I read that a special tool is required to press them back in and probably to remove them too. The tool may also flare the end on the opposite side to hold it in place.
Posted By: roadhazard
Re: holley carb question - 04/07/10 05:10 PM
Send the carb to Ben @ PROMAX and have him fix it properly for you 
Posted By: Commando1
Re: holley carb question - 04/07/10 09:18 PM
I'm still back at why you would want to mess with the venturis of a 6-pak center 2 bbl... 
Posted By: BSB67
Re: holley carb question - 04/07/10 10:01 PM
Pressed in. BLP makes tools for installing and checking level.
Posted By: crowbait
Re: holley carb question - 04/08/10 02:18 AM
Well here is a picture of the damage.
Posted By: scratchnfotraction
Re: holley carb question - 04/08/10 12:07 PM
ouch!! did it go out the tail pipe? 
thats gonna need repaired for sure
thats gonna need repaired for sure
Posted By: crowbait
Re: holley carb question - 04/09/10 02:00 AM
It looked like that when I got it.