US Car Tool driveshaft loop-TTI X pipe fit

My car is a '72 Charger-small block, TTI headers with X pipe.
Will a US Car Tool driveshaft loop clear the exhaust in this application?
Neither the exhaust or loop is on yet, I'd rather find out if it's going to fit or not before I put it together.

Sorry all I have

mine didn't, I had to heat up the s-part that holds the loop. my x pipe is up ALOT tighter than the one posted though

Mine doesn't fit either. I have a TTi 3in X-Pipe, auto transmission. Not a smallblock tho.

Has anyone had a d-shaft break-loose with this brand and type loop ? ... With the mounting point way WAY to the front, I would be worried about it keeping the d-shaft contained.

its NHRA approved, its gotta be safe

I guess I'll try the loop after I get the exhaust on.
Sounds like it depends on the car whether it'll fit or not.
I could probably guess better after I get the headers on.

I had no luck putting one on my wife's '70 Barracuda. It's running a 440 with Hooker Comp headers & a 3" TTI X-pipe system. As stated in a previous post, the exhaust on her car fits much tighter than the one in the photo above. So tight in fact, that you cannot even see the exhaust in a side-profile shot.