Fiberglass to metal

A question for the body specialists. What is the process of melding a fiberglass hood scoop to a metal hood?

Thanks in advance for any replies.

Superfreak.

Fusor makes a glue for it as I'm sure more companies do. I will research it and get you a specific product. Which ever way you do it glue or another method I would recomend putting down a couple coats of epoxy primer to your prepped hood first that will give whatever substrate you use a good surface to bite to.
http://www.repaintsupply.com/pd_127ez128ez.cfm

Quote:

---

A question for the body specialists. What is the process of melding a fiberglass hood scoop to a metal hood?

Thanks in advance for any replies.

Superfreak.

---

don't spend your time or money on anything other than Marine-Tex, this stuff is the best and will not leave a ghost line,will not crack or bubble even on high stress areas, It has proven it's self to me over the years,the only downside, it's expensive and takes about 5-6 hours to setup and cure

any marine supply store carries it,it comes in gray or white, both work with same results