Posted By: DART67GT
Edelbrock Gasgacinch - 01/18/10 11:42 PM
I'm ready to install my Air Gap intake to the Eddy heads. The instructions say to use the Gascacinch sealant on the gaskets. I have some, but the instructions on the can differ from the intake install instructions. Has anyone used this stuff? Do I just use on the head and the head side of the gasket? Is anything required on the intake side? I'm using Felpro gasket 1213.
Posted By: bobby66
Re: Edelbrock Gasgacinch - 01/19/10 12:06 AM
I'd use it on both sides of the gasket. Probably a lot like the "Indian Head" shellac/sealer.
Posted By: Lefty
Re: Edelbrock Gasgacinch - 01/19/10 12:16 AM
I don't think you want it on the synthetic rubber bead.
Quote:
Many Fel-Pro Performance Intake manifold gaskets utilize a synthetic rubber bead where applicable for superior sealing around intake and coolant ports.
http://www.jegs.com/i/Fel-Pro/375/1213/10002/-1#
Posted By: RapidRobert
Re: Edelbrock Gasgacinch - 01/19/10 12:57 AM
sparingly on both sides and I'd toss the end (front/rear) supplied gaskets and use a wide/thick swath of clear silicone instead on CLEANED block/intake surfaces.