Posted By: 67PLY
727 Front tranny seal....... - 10/16/09 11:10 PM
How hard is it to replace the front pump/converter seal while the 727 is still in the car/truck? Engine is being pulled for a swap.
727 Front tranny seal.......
Posted By: prochargedhemi
Re: 727 Front tranny seal....... - 10/16/09 11:12 PM
easier then riding a bike, pop it out make sure everything is clean and reinstall new one
Posted By: JoesMopar
Re: 727 Front tranny seal....... - 10/16/09 11:18 PM
It's easy once the engine is out , BUT, the convertor can be a PITA to get out sometimes.
Would it not be easier to just the pull the engine and tranny together and put them back in together?
Would it not be easier to just the pull the engine and tranny together and put them back in together?
Posted By: 67PLY
Re: 727 Front tranny seal....... - 10/16/09 11:25 PM
It's in an '84 Power Ram 4x4 truck.....the transfer case is attached the tranny.
Posted By: buildanother
Re: 727 Front tranny seal....... - 10/16/09 11:26 PM
Piece of cake. Only tricky part is removal of existing seal. 
Posted By: John_Kunkel
Re: 727 Front tranny seal....... - 10/17/09 08:44 PM
After driving the new seal in, shine a flashlight in the hole to make sure the garter spring didn't pop off of the seal.
Posted By: gtx6970
Re: 727 Front tranny seal....... - 10/17/09 08:49 PM
Quote:
It's easy once the engine is out , BUT, the convertor can be a PITA to get out sometimes.
If the convertor is hard to remove you have other issues to deal with besides a leaky seal