Posted By: srunge55
stock 440 valve covers - 09/22/09 02:12 AM
Will stock 69 440 valve covers work with Crane Gold rockers (1.5) on Edelbrock heads? Any clearance issues or do I need a taller cover?
Thanks,
Steve
Posted By: JohnRR
Re: stock 440 valve covers - 09/22/09 01:20 PM
The rockers , at a minimum the adjusters , will hit the baffles in the cover, you'll need to raise the covers up , try doubling a gasket , if you want to keep your stock covers .
Posted By: srunge55
Re: stock 440 valve covers - 09/22/09 03:18 PM
That is what I was afraid of. Thanks.
Posted By: 05dakota
Re: stock 440 valve covers - 09/22/09 03:30 PM
does anyone make a spacer?
Posted By: Jeff_383
Re: stock 440 valve covers - 09/22/09 03:30 PM
I have Comp pro magnums on my 500 with stock 440 covers and standard felpro gaskets. I did dimple the baffles just a little. They work fine for me.
Posted By: @#$%&*!
Re: stock 440 valve covers - 09/22/09 04:42 PM
I'm running '77 vintage covers with Harland-Sharps, 0.650" lift and standard cork gaskets. One still has the factory bar code on it. I did have to modify the end exhaust rockers but they have surplus material that shouldn't be there anyay. Measure the distance from the flange to the baffles and post it.
Cory
Posted By: srunge55
Re: stock 440 valve covers - 09/22/09 06:22 PM
I'll do that when I get home tonight. Thanks
Posted By: Mr.Yuck
Re: stock 440 valve covers - 09/22/09 07:11 PM
You'll have to "work" the baffles to make them work
Posted By: Robbins
Re: stock 440 valve covers - 09/22/09 08:48 PM
Are you running aftermarket heads? This reason why I ask is I was told the golds would hit my sb 273 valve covers and they didn't, but........I'm running E-brock heads.
Posted By: srunge55
Re: stock 440 valve covers - 09/22/09 09:11 PM
I am running edelbrock heads also. I guess I'll just have to mock it up and see.
Posted By: TonyS451
Re: stock 440 valve covers - 09/22/09 09:17 PM
I have 68-69 BB stock valve covers on my 505" with Stealth heads. They fit fine after hammering the baffles a bit.
Posted By: Sublime69
Re: stock 440 valve covers *DELETED* - 09/22/09 09:56 PM
Post deleted by Sublime69
Posted By: srunge55
Re: stock 440 valve covers - 09/22/09 10:43 PM
Great info, thanks. I will double check my measurements on my valve covers.
Posted By: pnypwr
Re: stock 440 valve covers - 09/23/09 12:24 AM
I have crane gold rollers on my iron 452 heads with stock 68 covers...no hamma needed! I doubt the eddie heads have a shorter flange than stock!
Posted By: DAYCLONA
Re: stock 440 valve covers - 09/23/09 03:30 AM
Running Crane Gold 1.6 rockers on 906 440 heads, 70 valve covers, had to remove the baffles for clearance,....no issuses with oil leaks or seepage or PVC oil draw being ecessive
Mike