1.130" ID, 3/8", 7* valve spring retainers

Beside HUGHES ( PN 1256 ), what other vendor does have that measure on retainers that could keep the stock installed heigh OR maybe add some stationary pressure without use shims ?

and on a similar price ( or cheaper if posible )

You may have to research several of the cam companies to see what they offer.
The Hughes 1256 Retainer is 3/8" stem, 7-degree lock, +0.075" install height, 1.375" outer diameter,
1.130" middle step diameter, and 0.730" inner diameter, and cost $62.00.
Are you looking for a retainer with the same diameters, but without the increased install height?
Which valve spring is this for? If it is for something like the 1106 spring the spring is a single with damper, 1.540 OD, 1.130" ID.
I think it would be easier to just shim the spring ?
Manley has a 1.130" 23636-16 standard height retainer, but it is for 10-degree locks. The retainers are $50, but you would need the 10-degree locks too (Comp 612-16 are $20.00.)
A Comp 749-16 may work $49.25 (1.125" id), but it is also for 10-degree locks.

I just found this one that may also work, Lunati 75713LUN. This is for 7-degree retainers, and is 1.500"x1.125"x0.700", and costs $44.95.

FWIW, I priced these from Summit.

Quote:

---

Are you looking for a retainer with the same diameters, but without the increased install height?
Which valve spring is this for? If it is for something like the 1106 spring the spring is a single with damper, 1.540 OD, 1.130" ID.

---

exactly, and since valve springs are used I'm getting 120 PSI ( seller acclaimed just 4K miles on them, so trusted ) at installed height specs by Hughes ( 1.880", what should it be 150 )

but when I got them ( at Carlisle last year ), IN MY IGNORANCE never thought on retainers.

I'm just watching another options.