Posted By: RapidRobert
JB weld to fix a casting flaw? - 07/02/08 06:24 PM
915 heads. the divider in between one pair of intake ports has flaws & is missing material & needs to be built up. Would JB be OK for this & if not would you guys recommend anything else? Thank you for your time.
Posted By: slantzilla
Re: JB weld to fix a casting flaw? - 07/02/08 07:08 PM
I've seen a lot tougher stuff than that fixed with JB Weld. Go for it.
Posted By: BobR
Re: JB weld to fix a casting flaw? - 07/02/08 07:15 PM
PM RyanJ and ask him what he uses in ports. I remember him saying that the stuff that he uses(not JB Weld) is bulletproof. -Bob
Posted By: JohnRR
Re: JB weld to fix a casting flaw? - 07/02/08 08:42 PM
if something is bullet proof they'll just make better bullets ...
that aside Moroso A B epoxy ...
but JB weld will probably work also .
Posted By: RapidRobert
Re: JB weld to fix a casting flaw? - 07/03/08 04:50 AM
I am going to get ahold of ryanj
Posted By: 6PKRTSE
Re: JB weld to fix a casting flaw? - 07/03/08 11:51 AM
We use a bowling ball epoxy here at work. We order it from a place called Baker & Collinson 1-313-366-2100. Not cheap though, its like $150.00 for a 1 gal. unit part A & B.
JB is good on the outside cracks, But not IN the ports where it can do some damage if it comes loose.