Hemi motor mount holes in block?

Posted By: kjh440

Hemi motor mount holes in block? - 05/25/09 08:30 PM

I have my hemi that I am getting ready to put into my barracuda. It has been installed with a motor plate before but I want to use motor mounts. The pads are on the bolck but are not machined to accept the bolts.

Does anyone have the pattern layout and depth of these 3 bolt holes per side?

Posted By: torkrules

Re: Hemi motor mount holes in block? - 05/26/09 12:17 AM

Quote:

I have my hemi that I am getting ready to put into my barracuda. It has been installed with a motor plate before but I want to use motor mounts. The pads are on the bolck but are not machined to accept the bolts.

Does anyone have the pattern layout and depth of these 3 bolt holes per side?

Don't have a pattern, but I'd imagine if you got the mounts you could use as a template. They are drilled right thru and are for 7/16" bolts.

Posted By: JohnRR

Re: Hemi motor mount holes in block? - 05/26/09 01:24 PM

is that pad machined flat or left as cast ?

As said above they a drilled straight thru but you need to know exactly where .