HS rockers on Indy EZ-1 heads ??

Anyone using Harland Sharp rockers on Indy EZ-1 heads ?? How is the fit?

I've seen a number of Indy heads set up w/ HS rockers and they always looked like a good combination to me; never heard people complain about the fitment.

I have the HS gold version non bushed bought from Mancini, these were apparently a limited version. I have had no problems with them on Indy EZ heads.

I run HS rockers on my EZ-1 heads with no issues.

I buy and use Harland Sharp 1.65 ration on every Indy heads I used, including at least one set on a set of the EZ295 heads . They fit well and work excellent, a lot better than most of the cheaper choices

So they're the standard 40-year-old design for big block Mopars?
How is the alignment over the valve tip - do they sit to one side or the other or are they pretty much centered?
What about grinding for pushrod clearance - did you have to do much of that?
Basically, what did you have to do to make them fit and work properly - if anything?