Posted By: 73cuda340
Torsion bar install - 09/04/23 07:11 PM
I just finished installing the new torsion bar on the drivers side of my cuda and I noticed that between the end of the torsion bar and the groove for the retaining clip, there is approximately a 1/2" gap between the two. I don't remember there being this much space with the original bars. I also installed new QA1 lower control arms with the firm feel 1.06" bars and hotchkis adjustable strut rods, so I'm not sure if the gap is due to all of the new parts. I don't know if this is even an issue, however I'd rather ask while everything is still loose.