Posted By: whitemtnelf
oiling with solid roller rockers - 06/13/08 04:12 PM
Are any mods needed to get the correct oiling up to the rockers when using solid roller lifters on a 440?
Thanks
Thanks
Quote:
Not as long as the block is still feeding the rocker shafts like the factory built them.
Quote:.Quote:
Not as long as the block is still feeding the rocker shafts like the factory built them.
Correct. Also make sure the after market shaft has slightly enlarged holes where the oil goes into it. The bolt takes up some of the space so the hole has to be a little larger on that one(both sides). Make sure shaft has the holes pointed down when installed. -Bob