Need 3 way Brake Booster Vacuum check valve

Hello Again Moparts. Does any one know of where I can find a 3way vacuum valve for a 1968 Charger please.

Bendix or Midland-Ross booster?

Not sure it was a replacement from Napa About 15 years ago and I accidentally broke one of the.nippleal off.working .on the starter relay.
Any way I could tell Which it is ?

Midland Ross left, Bendix right.

If you do not find one I have had good luck repairing them.

Go to Hobby Lobby or other hardware/craft store and look for steel/brass/aluminum tubing.

Find one that fits inside the nipple or at least close to it. I often have to clean the nipple by hand with a small drill bit.

Slide the tube inside the nipple and check valve body leaving about 1/8" space between the nipple and the body. This allows the glue to be able to adhere to the tube, nipple and check valve body.

Seal it up with epoxy and if needed you can file/trim the epoxy to hide the repair.

I leave the tube sticking out a little and after the repair is done I cut it and gently flare the tube to the end of the nipple.

If you lost the nipple you can use a generic nipple from any parts store.

Works great for those unobtainable gas tank vent valves and such.

Hope it helps

Thanks for the repair tips but if I can get a new one that would be best .
To answer the question about what one I have it looks like the one in the top picture above .

Which 'top' picture, right or left?

Sorry on phone it looks like top. I checked on a computer it is the Left picture.
Thanks for being patient with me.

Here you go.

Midland Ross Booster Check Valve

That looks exactly like it.
Thank you 6pakBee !!!!