Posted By: PC-CHARGER
2nd Gen Hemi mounts - 10/08/20 04:37 PM
Does anyone have a drawing showing the location of the engine mount holes on a 2nd Gen Hemi.The ones I need are the three bolt holes that hold the mount bracket to the side of the engine.
Posted By: 410mopar
Re: 2nd Gen Hemi mounts - 10/09/20 03:10 PM
Do you want a real official drawing, or can I just measure my 65 brackets and give you the measurement?
Posted By: dragon slayer
Re: 2nd Gen Hemi mounts - 10/10/20 11:52 AM
I am confused. Your talking 426 hemi correct? Left and Right brackets are different, B and E are different. Also some changes over the years. Yes the block studs are the same and if that is the pattern you need, you can pull it from a block,
Posted By: Suregrip391
Re: 2nd Gen Hemi mounts - 10/10/20 12:02 PM
He probably has one of those earlier blocks with the 440 mounts and needs to drill and tap for original Hemi mounts on the pad because they were not done when the block was machined. I had one of those once.
Posted By: A727Tflite
Re: 2nd Gen Hemi mounts - 10/10/20 12:03 PM
Brackets also differ between the 64-65 and the 66-71.
Posted By: 410mopar
Re: 2nd Gen Hemi mounts - 10/10/20 05:43 PM
PC-Charger
Please clarify. What exactly do you want? I'm willing to help.
Posted By: rickseeman
Re: 2nd Gen Hemi mounts - 10/12/20 11:52 PM
The diagram is in the Mopar engine manual
Posted By: Cab_Burge
Re: 2nd Gen Hemi mounts - 10/13/20 01:26 AM
Brackets also differ between the 64-65 and the 66-71.
Street hemi versus race steel block hemi mounts also
