Posted By: hemienvy
Steering column: tree shift to floor shift conversion - 05/09/20 07:36 PM
The column shift setup has a illumination lamp to show the gear selector position.
The factory manual does not show detail for a floor shift steering column, this is 1970 E-body.
I can't tell if the floor shift column needs this lamp, but I can't see why it would.
I'm asking because to remove the lamp bracket from the collar, you actually have to cut the wire,
I don't see how this could have been assembled at the factory. So if I don't need the lamp
in the new set-up, I'll just cut it and then remove the female connector from the turn signal switch harness connector.
Don't seem right somehow.
The factory manual does not show detail for a floor shift steering column, this is 1970 E-body.
I can't tell if the floor shift column needs this lamp, but I can't see why it would.
I'm asking because to remove the lamp bracket from the collar, you actually have to cut the wire,
I don't see how this could have been assembled at the factory. So if I don't need the lamp
in the new set-up, I'll just cut it and then remove the female connector from the turn signal switch harness connector.
Don't seem right somehow.