Posted By: Triggerfish
1 78" headers avail for 64 Belvedere with 383? - 07/15/18 01:14 AM
Has anyone installed 1 78" headers in a 64 B body with low deck motor? If so, any fittment problems or mods needed?
Posted By: lewtot184
Re: 1 78" headers avail for 64 Belvedere with 383? - 07/15/18 03:47 PM
to my knowledge nobody makes a 1 7/8" header for an early b-body. I think you can use a tti 1 7/8" if you use the later k-member the sets the engine back.
Posted By: therocks
Re: 1 78" headers avail for 64 Belvedere with 383? - 07/15/18 05:27 PM
I ran a set inm my 65 the same body/I ran a 440 though.Still have them hanging in the other garage as I run 2 inch TTIs.If TTi makes a set for 65 they should fit 64.Oh there are no B bodys in 64.All Plymouhs wre the same body just different trim same with dodge except for such as dart valiant etc.Rocky
Posted By: Triggerfish
Re: 1 78" headers avail for 64 Belvedere with 383? - 07/15/18 06:03 PM
Thanks for the info & I guess I'll call Dougs & TTI tomorrow to see what they've got.
Posted By: hosehead
Re: 1 78" headers avail for 64 Belvedere with 383? - 07/15/18 06:59 PM
I was in the same situation when I built my street strip motor. Went from the 1-3/4" tti to the 2" as they don't offer 1-7/8". 2" headers still fit great on ,y 65 belvedere. Tti is a great product.
Posted By: lewtot184
Re: 1 78" headers avail for 64 Belvedere with 383? - 07/15/18 07:34 PM
the 1 7/8" tti's are made for the '66 and up chassis.