2003 Dodge Durango question

I'm replacing upper control arms on a '03 Durango 4x4 and I'm looking for torque specs for the mounting nuts,bushing nuts, and ball joint nut. Thanks in advance. Ready... go!!

TORQUE
DESCRIPTION

Upper Control Arm Frame Nuts
163 Nm
120 Ft.Lbs
—
Upper Control Arm Axle Nut
163 Nm
120 Ft.Lbs
—
Hub/Bearing Bolts
202 Nm
149 Ft.Lbs
—
Axle Nut
179 Nm Beginning Torque, Then Rotate 5 to 10 Times With a Final Torque of 356 Nm
132 Ft.Lbs Beginning Torque, Then Rotate 5 to 10 Times With a Final Torque of 263 Ft.Lbs
—

BallJoints.....
Upper 60 Ftp
Lower 94 Ftp

Upper Control Arms
Pivot Shaft to Frame 155 Ftp
Pivot Shaft 130 Ftp

Thank you,CARMAN. This is a big help. I put a set in the same Durango 45-48000 miles ago ,Dorman brand, the ball joints are wasted. Installing Moog this time , hopefully the last time. The only thing good I can say about the Dorman part is that it came with a chart of torque specs. Thanks again and as always MOPAR OR NO CAR!!

No problem. Be careful of the moog I replaced all of my balljoints in my 02 Durango and they were all junk within 6 months. The lower's where squeaking and would no longer accept grease. The uppers where just falling apart. I put napa brand upper and lowers in this time. They where more money but looked and felt like a better product. Been about 5 months now and everything is still tight.

In January I wasted money on a defective clock spring.
Dorman is junk.