Posted By: Erik
Charger Specialties Circuit Boards - 12/04/17 04:56 PM
Recently I replaced the circuit boards in my Barracuda with new one from Charger Specialties. When I got everything back together, the temp and oil pressure gauges stopped working. So I pulled the dash back out and noticed a glob of solder that was touching both the bottom pins where these gauges connect. I carefully removed the glob and put it all back together. Gauges still don't work.
Has anyone has this type of problem with their boards?
Posted By: Andrewh
Re: Charger Specialties Circuit Boards - 12/05/17 01:47 AM
never used them.
did the gauges work before?
did you test them?
2 AA batteries in series wired to each side. they are slow to respond so give it a little bit see if they move.
Posted By: floridian
Re: Charger Specialties Circuit Boards - 12/05/17 01:59 AM
Have you contacted the supplier with your problem to see if they can help or have any suggestions?
Posted By: blewbyu
Re: Charger Specialties Circuit Boards - 12/05/17 03:41 PM
I have one but have not installed it yet. I know there is some specific instructions did you follow them?
Posted By: Erik
Re: Charger Specialties Circuit Boards - 12/05/17 04:09 PM
Yes, the gauges worked before I swapped the boards.
Yes, I contacted the manufacturer who told me to test the voltage.
They did not come with instructions, but they are very simple to install.