Moparts

Hose to big for fuel filter. Video incl.

Posted By: xyxxjx

Hose to big for fuel filter. Video incl. - 08/14/16 10:43 AM

I've put on a new fuel pump and fuel filter. As can be seen in the video the hose from the filter to the carb is too big. I'm showing the hose bit that came with the filter in the beginning of the video. What would be best here, get a smaller hose (will it fit the carb) or put the bit that came with the filter on and use some sort of connector?

http://sendvid.com/cffkqiv2
Posted By: 71rm23

Re: Hose to big for fuel filter. Video incl. - 08/14/16 11:42 AM

Uh, what video?
Posted By: xyxxjx

Re: Hose to big for fuel filter. Video incl. - 08/14/16 01:03 PM

Originally Posted By 71rm23
Uh, what video?


Crap.. forgot link. drumhit it's up now.
Posted By: mikemee1331

Re: Hose to big for fuel filter. Video incl. - 08/14/16 01:47 PM

go get the right size filter? that inlet looks pretty small. the little piece that came with the filter is for going from filter to hard line.

you might be able to cut a 1/2 inch off your existing line to get a better fit. the rubber lines kinda stretch out and conform to what they were on.
Posted By: ngpSatellite

Re: Hose to big for fuel filter. Video incl. - 08/14/16 01:54 PM

First check if the hoses are all correct... 3/8 or 5/16.... which is spec for your ride??... is there a mismatch.... then .. is your new fuel pump output threaded so you can choose a barb to be conducive to your line size up to the carb,,, from "barb to carb" drumhit should be all one size.... the difference might not seem much (5/16 to 3/8) but its like the difference between your honeymoon night and the 20th anniversary!!...... shruggy
Posted By: bee1971

Re: Hose to big for fuel filter. Video incl. - 08/14/16 03:41 PM

Your trying to install a 3/8" hose onto a 5/16" fuel filter


Just buy some 5/16" fuel hose to run from filter to carb

Let's see your inlet barb into carb for size and fit

Anyways


Honeymoon versus 20 years - I hope I can make it to twenty years let alone have
Posted By: xyxxjx

Re: Hose to big for fuel filter. Video incl. - 08/14/16 11:10 PM

Wonder what the equivalent tube size would be for the 40th anniversary, maybe radiator hose. drumhit drumhit
Posted By: xyxxjx

Re: Hose to big for fuel filter. Video incl. - 08/14/16 11:33 PM

Here is a picture of the old and the new filter. The old filter is slightly bigger, not by much though, maybe 1/8". I've tried cutting a bit more off the end of the hose and now there is resistance when I put it on, not super tight like the others but snug enough so that I can lift it up by the hose. Would this not be good enough if i tighten the clamp extra snug?

https://drive.google.com/file/d/0B8IgeG75F_MIbjNTc2NWQzhUaWc/view?usp=drivesdk

Here's the filter type

https://drive.google.com/file/d/0B8IgeG75F_MISVUzSHgyWVlnUUk/view?usp=drivesdk
© 2024 Moparts Forums