rubber pushrod retainer

The little rubber piece that goes on manual brake rods to secure it in the master cylinder...where can you get these? Thanks.

Mancini racing has them.

I have used a small piece of vac tube in a pinch.. 1/4 or 5/16 hose IIRC

I did the same as Scratchn. The OE ones have a thin groove lengthwise alongside the OD from end to end possibly to let air excape so it will seat firmly in place either that or it is a mfr tool mark that is insignificant as far as functioning. Either way I added the groove/no issues. hand the p rod to your parts guy & have him cut a snip of whatever ID slips firmly on the round nub rod end just a hair shorter than the length of the recessed groove on the p rod (it'll likely be a freebe) & you're set

I have even used a parts store o-ring or small rubber washer, the grove is nessecary to air escape and seat properly IIRC - cut one in and be merry.

PLAZ

Thanks guys!

Same here.