1970 Cuda Driver Side Mirror Mounting Hole Locations

I just had the door skin on my drivers door replaced on my 70 Cuda and I need the correct dimensions for where to drill the three holes for the mirror. I also need the diameter of the center hole which is used for the remote cable to go thru.

-Thanks

If you're not in a hurry I could make you a template from my holes in door and put it in the mail. I'd of course take pics so you could verify correct placement and locations. PM me if that would work.

PM sent

Ok I took some pics with measurements. I measured from the inside door edge to get the vertical measurements.
Looks like 2 3/8 for first hole
2 5/16 for center hole
2 5/16 for rear hole
Horizontally from front of door edge is 17 1/4 and 20 1/4.

This is an original door and not sure how exact these measurements are compared to others.

Hope this helps

Center hole

Rear hole

Another

Front edge