What is the height of the M1 intake?

I really was hoping to run one of the Indy intakes on my 499, but they are just too tall to fit my modified Shaker set-up. I understand that the Victors are about 6.25" tall and that the Indys are about 6.75" tall. Both a little too tall. I have been running a Holley SD with 1.375" spacers for a total height of about 5.75" and have modified my Shaker base to fit that height with a Dominator carb. So.......does anyone know the height of Mopar's M1?
Thanks!

I put a straight edge on the carb flange and measured 5 inches in the front and 5 3/4 inches in the rear. This is a M1 4150 flange for 440.

Thank you for taking the time to measure that for me.