Posted By: GTX MATT
Bellhousing interchange - 02/02/12 06:02 PM
I have a bellhousing with a PN 2468370. Brewers lists it as a '65 B/C body bellhousing. Would this work for my '67 B body? If not what will be the issue.
Bellhousing interchange
Posted By: JohnRR
Re: Bellhousing interchange - 02/02/12 06:21 PM
Yes it will work, 130 tooth wheel and 4.35 bearing retainer hole. The only issue MAY be the attachment of the Z bar.
Posted By: Dan Brewer
Re: Bellhousing interchange - 02/02/12 08:29 PM
Yep. Will work no problem. Ballstud will screw in lower of the 2 holes. You might have to change fork pivot depending on what it origanlly came out of. Dan
Posted By: GTX MATT
Re: Bellhousing interchange - 02/04/12 07:38 AM
Quote:
Yes it will work, 130 tooth wheel and 4.35 bearing retainer hole. The only issue MAY be the attachment of the Z bar.
Alright that is what I was worried about, where might I run into an issue? Is the bracket on the frame in the same location relative to the bell housing on '65 and '66/'67?
Posted By: JohnRR
Re: Bellhousing interchange - 02/04/12 03:06 PM
Quote:Quote:
Yes it will work, 130 tooth wheel and 4.35 bearing retainer hole. The only issue MAY be the attachment of the Z bar.
Alright that is what I was worried about, where might I run into an issue? Is the bracket on the frame in the same location relative to the bell housing on '65 and '66/'67?
No idea on bracket location, but rapidfire above said it will work.
Posted By: GTX MATT
Re: Bellhousing interchange - 02/05/12 07:32 AM
Alright thanks guys 