throw-out bearing install/is this right?

Print Thread

throw-out bearing install/is this right? #1211065 04/06/12 06:18 PM 04/06/12 06:18 PM
Joined: Feb 2003 Posts: 2,138 tucson az F frank OP top fuel
frank OP top fuel F Joined: Feb 2003 Posts: 2,138 tucson az	Installed the new fork in the stock bellhousing. Installed the bearing on the fork. The bearing is not even close to being centered over the pressure plate fingers. I can move the bearing against the springs and get more centered but it will not stay in this position. Is this normal?? According to Brewers I need .040-.060 clearance between the bearing and the fingers. According to Brewers all parts are correct. Please advise. Thanks

Re: throw-out bearing install/is this right? [Re: frank] #1211066 04/06/12 07:19 PM 04/06/12 07:19 PM
Joined: Jan 2003 Posts: 904 Berwyn, IL M Moparlar super stock
Moparlar super stock M Joined: Jan 2003 Posts: 904 Berwyn, IL	The bearing will center itself on the front bearing support when you install the tranny. LArry

Hop To