440 w Holley 750, dual feed line - hits distributor.... - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer 440 w Holley 750, dual feed line - hits distributor....

Print Thread

Page 2 of 2

1

2

Re: 440 w Holley 750, dual feed line - hits distributor.... [Re: WyleECoyote] #653803 03/30/10 08:29 PM 03/30/10 08:29 PM
Joined: Jan 2003 Posts: 1,069 Washington State 70Duster440 super stock
70Duster440 super stock Joined: Jan 2003 Posts: 1,069 Washington State	I happen to run a carb spacer but got creative with the dual feed. Hard line up from the pump, bends to the center, through a regulator, and then curves up and around the coil before entering the feed at a right angle. 5897368-Plumb.jpg (154 downloads)

383man [Re: dirtybee] #653804 03/31/10 01:59 AM 03/31/10 01:59 AM
Joined: Jan 2003 Posts: 27,421 Balt. Md 3 383man Too Many Posts
383man Too Many Posts 3 Joined: Jan 2003 Posts: 27,421 Balt. Md	Quote: by the way, 383man, your engine and car are top notch. Thank you. Ron

383man [Re: 383man] #653805 03/31/10 02:09 AM 03/31/10 02:09 AM
Joined: Jan 2003 Posts: 27,421 Balt. Md 3 383man Too Many Posts
383man Too Many Posts 3 Joined: Jan 2003 Posts: 27,421 Balt. Md	I found this pic which has a better veiw of the carb fuel line with a 90 in it. Ron

Page 2 of 2

1

2

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1