any one on hear have any dyno results on the new eddy victor hemi heads

Here is My 572 with the Eddie heads

here is the engine

nice

I like those numbers !
Care to share some specs on the build ?
Valve sizes, Cam specs , comp ratio, etc.

Thanks,
Mark

That is a mean looking engine

Very nice DoubleD!!!

The Victor heads flow 420+ with fairly modest runner volumes and very little rework.

They're pretty nice.

Just curious about how the Eddys compare the the Indy HiPo heads that have the big valves. The look the same to me as if Edelbrock copied the Indy's.

The Victor head has a 245cc intake runner with a 2.32 intake valve..... The Indy hi-po is 266cc with a 2.40 valve.

the Indy HiPo are the former Canfield heads which were a modified version of the original Mopar/Eddie heads - the difference in the Victor Jr. heads are that they have push rod tubes and the big valve - the heads are similar but different

Sweet engine & nice power. Almost the exact same power & torque #'s my 528" Hemi Made.

Nice looking motor plate!

looks even better in the car

Looks great...I'd suggest getting rid of that chrome water pump outlet fitting for a billet aluminum piece from 440S or Mancini's...every chrome outlet I've had, Mopar or off brand, warps and leaks like crazy. Had mine burst at the Mopar Nat's two years ago, Mancini's saved the day.

You put the motor plate mounts on the wrong side
of the plate.. just makes it harder to get the
engine out because you have to go up and over the
mounts.. always put the mounting plate to the rear

That was just a test fit - had to move the HEMI back a 1/2 inch from where the wedge was- they are in the right place now - you guys don't miss a thing .........

wedge before HEMI

DD, for your dyno test are those heads out of the box, or is there some work done on them? THose are some stout numbers.

Do you mind saying what type of rework? Valve Job? Bowl blend? Something else?