Topic Options
#2414118 - 12/06/17 09:12 AM Removing K-Frame/Engine from Bottom - 69 Dart
Pntastar69 Offline
master

Registered: 01/20/03
Posts: 2711
Loc: Gilbertsville, PA 19525
In the process of removing the k-frame/engine/trans from the bottom. Can I use the ends of the bumper brackets as the lifting point to attach the hoist? Will they support the weight?

Thanks
_________________________


Mark

Top
#2414136 - 12/06/17 09:37 AM Re: Removing K-Frame/Engine from Bottom - 69 Dart [Re: Pntastar69]
dodgy Offline
member

Registered: 01/28/03
Posts: 127
Loc: Australia
have done what you describe however I used two bits of angle iron instead of the bumper brackets with a bar joining the two together with lift point centred, not a lot of weight after motor trans and front end is unbolted.

Top
#2414138 - 12/06/17 09:38 AM Re: Removing K-Frame/Engine from Bottom - 69 Dart [Re: Pntastar69]
Neil Offline
I Live Here

Registered: 01/19/03
Posts: 12798
Loc: Eagle, Idaho
I think you would want to put something in-between them so they don't pinch together.

Top
#2414145 - 12/06/17 09:55 AM Re: Removing K-Frame/Engine from Bottom - 69 Dart [Re: Pntastar69]
Pntastar69 Offline
master

Registered: 01/20/03
Posts: 2711
Loc: Gilbertsville, PA 19525
Good point Neil. My plan is to bolt a 2 x 2 x 1/4" square tube to the front of the brackets.
_________________________


Mark

Top
#2414295 - 12/06/17 02:22 PM Re: Removing K-Frame/Engine from Bottom - 69 Dart [Re: Pntastar69]
Neil Offline
I Live Here

Registered: 01/19/03
Posts: 12798
Loc: Eagle, Idaho
That should work. Bumper brackets should be more that strong enough to lift the front end up.

Top
#2414495 - 12/06/17 09:24 PM Re: Removing K-Frame/Engine from Bottom - 69 Dart [Re: Pntastar69]
davesmopars Offline
master

Registered: 08/01/04
Posts: 2879
Loc: cheshire, ct
Get the rear tire off the ground also 6 to 10 inches you will not have to lift the front as high

Top
#2414583 - 12/07/17 05:45 AM Re: Removing K-Frame/Engine from Bottom - 69 Dart [Re: Pntastar69]
Pntastar69 Offline
master

Registered: 01/20/03
Posts: 2711
Loc: Gilbertsville, PA 19525
Thanks guyz.
_________________________


Mark

Top

Advertisement
Forum Stats
25,489 Registered Members
32 Forums
193,038 Topics
2,253,383 Posts

Most users ever online: 1,424 @ 06/20/18 07:18 PM
Moparts Newest Topics
Vintage dual quad Edelbrock small block aluminum manifold
by Alaskan_TA
09/22/18 03:22 PM
Tire date codes, can someone decode these for me?
by RV2
09/22/18 02:53 PM
rear sway bar in Cuda with Dana 60
by FJ6AAR
09/22/18 02:11 PM
70 Challenger passenger rear 1/4 patch panel
by RROD
09/22/18 01:08 PM