Any one have photos of window net installed on a slant bar roll cage? Got to install one in a duster.

Don't know if you can see it right or not, but here is mine.

Here's a differnet one.

Remember to weld all the attaching points to the inside part of the cage.


I still need to redo mine

This quick and useful response is why this site is so valuble. Thanks guys. Any more?

Here's a couple for you. You can see a tab in the back just below the cross bar and another tab on the down bar.

Here's a pic with the net. When unbuckled at the top it sort of hinges down out of the way.

I have a clevis pin with a R clip I use at the top so I can drop it down out of the way easily for trips out for ice cream

BIGCUBE:

This is the idea I had. How do you have the rod (L-shape) at the bottom of the net attached? Does this rod swing in to the inside when you un-buckle at the top?

Thanks I'm getting some good ideas. Got to get this in before Pinks at Charlotte.

One end under the cross bar is bolted so it will hinge down. At the front there is a threaded stud with a washer and nut on the bottom side. The front end of the L will slide down through the bracket, it will pull up until the washer hits the under side of bracket.