Which pan sump do i need for a lo deck in an 67 A body? seen a nice stefs aluminum pan in the for sale section.

Most center sump pans will work,but the distance from the front pan rail to the sump I think has to be 5". This means the oil pan for a E-body like the Milodon 6qt unit wont work.

ok, thanks chris, just want i needed to know.

You will need clearance for the idler arm also

ok

I used a Mopar low profile 6 quart 1970/71 Hemi and 440 6 pak oil pan in my old Duster, I did slide the motor back one inch with elephant ears up front and I had to slot the stock V8 tranny mount to make it fit that way I did need to grind a tiny little bit, around a 1/4 inch, off of the K member rear lip on the passenger side front edge that was near the oil pan corner I also slid the rear end forward one inch with ladder bars and coil overs while stretching the rear wheel wells so I could put a bigger rim and tires on it for the increase power That car was almost 50 % weight on the front and back with me in it

If you have a choice among more than 1 that fits, you want:
1st: deepest "full" level and lowest pickup position
2nd: highest volume up to the pan rail (not just to the "full" level)

Can i get an off the shelf pan for this combo?

Moroso 8 ot pan fits,as does the Mopar 6 qt. Milodon has the pan that is a low profile,it fits too.I've used all 3 pans I've mentioned in a BB/A body car.

Ok thanks again chris.

charliesoilpans.com will build you a pan if needed

moneys very tight right now with this build. starting from cratch sucks, so will be getting the moroso 8qt pan Chris mentioned. found it at jegs for $134. very affordable right now. thanks

Same pan on Ebag from KMJ Performance...about 80 bucks...

What is your intended RPM ?

milidon oilpump single static pickup milidon low profile 7 quart oilpan 7000 rpm,s

thanks chris. 6500rpm ceiling.

Dave you wouldnt happen to have a link to this pan would you?

no but jegs had it. Ill see if i can find the part number.

been searching for that pan. Cannot find it. It was a black 8qt center sump bb moroso pan. Part number started with 500. Ill look harder when i get home.

The only reason i ask is because the only advertised one i could find that was 8qt for a good price was this one
http://www.jegs.com/i/Mopar-Performance/312/P5007816/10002/-1
And was curious if this is the same one or if i was just overlooking it?