Anybody know where to buy these things new? They sell wiring new with them on there,here is a picture with two of them.

NAPA,buy them in bulk,cheaper that way..

....or, I have bought them from Terminal Supply Co. (in MI from memory) in the past too.

Those look like the same ones used in gm bulkheads.

so what is the actual name for them? I could show them that same picture and say find me these but I might be there a while.

NAPA 725145 female 725147 male (packard 56 type). $$$

thank you,I will go check Napa.

I have a few. How many do you need?

Well I have been helping a guy rewire a car with stuff we found on ebay and much of it was in bad shape,would have been much easier to fix with new connectors instead of trying to pry open the crimps,solder new wire to old and recrimp the outer most crimp,basically after that I just want to buy a box of these things and have them on hand for later when I start going through my own wiring.

I will get some bought this week and try to find the crimp tool also,thx guys.

have a source or part number for the crimp tool?????

terminal supply or PCS connectors will have both the terminals and crimpers

Napa/Belden part number is no longer good,new company wants $.99 each!

http://www.pcsconnectors.com/packard56.aspx?page=2

Cole Hersee company also has them. I have also bought them from a company in Cincinnati, J & N Auto Electric. You have to be a dealer to buy from them, but if you give them a call they should be able to advise you where your nearest dealer would be.

Dan

http://www.clipsandfasteners.com/GM_56_Series_Female_Terminal_p/a8774.htm

$10.05 for 50

Accel, got 4 sets of interchangeable jaws, ratchets. Just looked no # but has yellow handles, well made. Can't remember exact $ but was a little pricey but sure works well!

I bought mine from the a place called the terminal repair store i bought 50 ea the male one was like $12 for 50 . i also have the crimper for these they say packard on them they are a ratcheting and do the double crimp for these terminals . i bought a nice used dash harness replaced all of the ends at the bulkhead and replaced the ends for the light and wiper harness ,

Terminal Supply, they have everything.

I bought a kit from them for automotive applications
that was great when rewiring our Charger.

Joe

The females are 2427736 and come the same way.

Just to confirm before purchasing...

this tool will crimp both male and female packard 56 terminals on mopar wiring harnesses?

http://www.amazon.com/SARGENT-Tools-1028...=I23NYY2UQ7C6T0

Read here that it does... However the product number was NOT given by the apparently very knowledgeable poster describing the crimp process... Since it was not firsthand I did not want to assume the other poster was correct...

http://www.thegaragegazette.com/index.php?topic=2924.0

As far as I can tell the sargent one does look like it is similar to the one above posted by 62maxwgn

Again just want to confirm before spending $30... I can't afford the full duty versions which are big $$'s as i won't use often...

TIA